Panasonic UB-5338C Operating Instructions Manual page 43

After unscrew the 4 screws from the lower
7
center frame cover, remove it.
Fasten the wall-mounting clasps of the unit
8
securely to the wall with the 4 appropriate wall-
mounting hardware.
Wall-mounting hardware
Note
• The 4 wall-mounting hardware are not
included with the electronic board. Please
purchase M6-size screws appropriate for your
wall.
Attach the lower frame cover removed in step 7.
9
• Advance to "Electronic Board Operations Check" on
page 45.
Assembling the unit
[Optional Stand]
Attach the optional stand to the unit.
10
• Each stands has four holes (A, B, C, D).
1) Attach the stand to the unit with the locking
caster up.
2) When attaching the unit to the stand at
normal height (1,830 mm [6'
the two screws (included in the stand) with
1 washers using the hexagonal wrench
through holes A and C.
[Normal height]
C
Note
• Use the washer included with the electronic
board. Do not use the washer included with
the stand.
• Do not tighten the screw too much. This may
deform the stand.
• By tightening the two screws with washers
through holes A and B, the unit will be
positioned 100 mm (3
normal height (1,930 mm [6' 4"]).
[higher than normal height]
C
B
2
/ "]), tighten
32
Screw
1Washer
B
A
15
/ ") higher than
16
A
43