Panasonic PT-L6510U Operating Instructions Manual page 44

Replacing the lamp unit
8. Insert the power cord plug into the wall outlet and then press the MAIN POWER switch.
Caution
• If the power does not turn on even after turning the MAIN POWER switch "I", turn the MAIN POWER "O",
confirm that the lamp unit and door are installed correctly, and turn on again.
9. Press the "POWER" button so that a picture is projected onto the screen.
10. Press the "MENU" button to display the
MAIN MENU screen, and then press the
and buttons to move the cursor to
select "OPTION2".
11. Press the "ENTER" button to display the
"OPTION2" screen, and then use the
a n d b u t t o n s t o s e l e c t " L A M P
RUNTIME".
12. Press and hold the "ENTER" button on
the projector or the remote control for
approximately 3 seconds.
The "LAMP RUNTIME" will change to "L1 RESET
[POWER OFF]" or "L2 RESET [POWER OFF]".
Note
• If the "MENU" button is pressed, the lamp time
resetting screen will be cancelled.
13. Press the
L1 RESET: Replace the LAMP1
L2 RESET: Replace the LAMP2
L1+L2 RESET: Replace the LAMP1 & LAMP2
14. Press the POWER button to turn off the power.
This will reset the cumulative usage time for the lamp unit to zero.
44
and buttons to select for replacement lamp setting.
MENU
INDEX WINDOW
PICTURE
POSITION
AUDIO
ZOOM/FOCUS
LANGUAGE
OPTION 1
OPTION 2
SELECT ENTER
OPTION 2
LAMP POWER HIGH
LAMP SELECT
DUAL
LAMP RUNTIME 1 1820 H
FUNCTION 1 INDEX
SET ID ALL
USER MODE
SELECT ADJ ESC
OPTION 2
LAMP POWER HIGH
LAMP SELECT
DUAL
[ POWER OFF ]
L1 RESET
FUNCTION 1 INDEX
SET ID ALL
USER MODE
SELECT ADJ ESC