Leveling The Projector; Adjusting The Vertical Position Of The Picture - Panasonic PT-L6510U Operating Instructions Manual

Commercial use
Hide thumbs Also See for PT-L6510U:
Table of Contents

Advertisement

Starting to use

Leveling the Projector

For the best viewing result free from distortion, the
projector should be carefully leveled on its base.
Follow the steps below to correct the tilt angle of the
projector when it is installed on a floor-standing base.
1. While lifting and holding the front side of
the projector to the level position, pull and
hold the LEVELING button on each side
of the bottom panel until the leveling feet
rest on the projector base surface.
LEVELING Lever
on each side.
Caution
• Keep holding the projector until both leveling
feet touch the base surface.
2. Release the LEVELING levers.
The leveling feet lock in place.
3. Make fine leveling adjustments by
manually turning the leveling feet.
Note
• The maximum length of the leveling foot is 47
mm. If it is rotated on reaching that length it will
turn freely without extending further.
• If the picture has keystone distortion, do
keystone adjustment from the menu. (page 32)
24
LEVELING feet
47 mm
<Retracting the Leveling Feet>
While lifting the front side of the projector, raise the
Leveling lever, and then slowly lower the unit.
Caution
• Do not press the LEVELING levers without
holding the projector with your hands.
Otherwise, the leveling feet will be unlocked and
the projector may drop rapidly onto the projector
base surface, possibly leading to damage.
Adjusting the Vertical Position of
the Picture
The vertical position of the picture can be adjusted
using the electric "LENS SHIFT" buttons on the rear
control panel. Do this adjustment after the projection
distance and projector position have been
determined.
• Adjusting vertical position with the "LENS
SHIFT" buttons:
Press the
button to shift
the picture upward.
Press the
button to shift
the picture downward.
• Adjusting vertical position from the menu:
Alternatively, you can adjust the vertical position of
the picture by choosing the "LENS SHIFT" option
from the "OPTION 1" menu chosen from the MAIN
MENU (see page 34).
Caution
When shifting the lens, be careful not to
catch your fingers between the lens and
shroud.
IN
IN
OUT
L
R
IN
OUT
OUT
IN
OUT
S-VIDEO IN
VIDEO
AUDIO IN
RGB
AUDIO AUDIO
USB
SERIAL
IN
R/R-Y/P
R
G/Y
B/B-Y/P
B
SYNC/HD
VD
OUT
RGB 1 IN
RGB 2 IN
RGB OUT
REMOTE
WIRED
IN
DVI-D
OUT
> PC <
TBMU152

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-l6600u

Table of Contents