Attaching The Management Module Ethernet Port To A Network37; Powering On The Power Source - Brocade Communications Systems ServerIron ADX 10000 Installation Manual

Attaching the management module Ethernet port to a network
The Management Module (MM) 10BaseT/100BaseTX/1000BaseTX Ethernet (management) port
(RJ-45 UTP connector) allows you to connect the management port to a network.
To attach the MM Ethernet port to a network, you need a Category 5 UTP straight-through cable
(not supplied by Foundry). Connect one end of the straight-through cable to the management port
and the other end to the network.

Powering On the power source

To power on the power source after completing installation, follow these steps.
1. Verify that all modules and power supplies are fully and properly installed and that no module
CAUTION
If you do not install a module in a slot, you must keep the slot blank in place. If you run the
chassis with an uncovered slot, the system may overheat.
2. If you are supplying a DC power source to a ServerIron ADX chassis, attach the power cables to
3. If your power source is AC, attach one end of a Brocade-supplied AC power cord to the AC
DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the regulations
for power cords in your country. The mark is your assurance that the power cord can be used
safely with the device.
CAUTION
AC outlet should be appropriate for the AC rating of the power cord plug.
NOTE
The wall outlet should be installed near the equipment and should be easily accessible.
Brocade ServerIron ADX Installation Guide
53-1002066-01
DRAFT: BROCADE CONFIDENTIAL
•
Flow control: None
slots are uncovered.
the DC power supply as described in
Connect the other end of the cables to the DC power source. Repeat this step for each installed
DC power supply. Then switch on the power source.
power supply as described in
Insert the other end into a 115V/120V wall outlet. Repeat this step for each installed AC power
supply.
Powering On the power source
"Connecting DC power to a chassis"
"Connecting AC power" on page 29.
2
on page 31.
37