Installing An Ssl Expansion Module Onto A Management; Module - Brocade Communications Systems ServerIron ADX 10000 Installation Manual

2
Installing ServerIron ADX
4. Push the ejectors in until they are flush with the module front panel. This action will fully seat
5. Tighten the two screws at either end of the module front panel by pushing them in and turning
Installing an SSL Expansion module onto a management module
The SSL upgrade kit provides the ability to add hardware-based SSL acceleration to a ServerIron
ADX management module that doesn't currently have this capability. This following instructions
describe how to install this upgrade kit.
Installation requirements
Allow approximately 1 half-hour to complete this procedure. Your installation site must meet the
following requirements to ensure correct installation and operation:
•
•
•
24
DRAFT: BROCADE CONFIDENTIAL
NOTE
When inserting the module into the chassis, make sure that the faceplate does not overlap
with the faceplate of an adjacent ASM Module.
the module in the backplane. Modules have a snug fit for maximum EMI protection.
NOTE
The installation instructions for installing modules shown in the following illustrations are
exactly the same for ASM, MM, and SFM, and Ethernet Interface Modules.
them clockwise. Then, tighten the screws further using the flat-head screwdriver.
You will need a #2 Phillips screwdriver to install the ServerIron ADX SSL Expansion Module
onto a ServerIron ADX Management module.
The installation must be performed on a flat surface with protection from ESD damage.
An ESD wrist strap that contains a 1 meg ohm series resistor.
Brocade ServerIron ADX Installation Guide
53-1002066-01