Installing An Interface Module In A Running System; Installing An Power Supplies In A Running System; Installing An Fan Trays In A Running System; Verifying Proper Operation - Brocade Communications Systems ServerIron ADX 10000 Installation Manual

2

Verifying proper operation

Installing an Interface module in a running system

You can install Interface modules into a running system without any service disruption. When the
Interface module is inserted in its designated slot in the ServerIron ADX chassis, it is automatically
detected and brought online.
NOTE
You must make certain that there is no configuration mismatch for the Interface module in that slot.

Installing an Power Supplies in a running system

Provided you maintain at least the minimum number of power supplies in a ServerIron ADX, you
can install new power supplies without incurring an impact to operation of the system.

Installing an fan trays in a running system

Fan trays can be installed in a running ServerIron ADX system provided you follow the limitations
described in
Verifying proper operation
This section describes how to verify proper operation of the ServerIron ADX chassis after power on:
•
•
•
•

Observing the LEDs - ServerIron ADX 1000

Table 2
If a problem persists after taking action described in this table, contact Foundry technical support.
TABLE 2
LED States After System Power On - ServerIron ADX 1000
LED State
1G Interface Ports
On
Blinking
Off
10G Interface Ports
Link Solid green
Off
42
DRAFT: BROCADE CONFIDENTIAL
"Uninstalling a Fan module"
"Observing the LEDs - ServerIron ADX 1000"
"Matching LEDs to locations on the ServerIron ADX 1000"
"Observing the LEDs - ServerIron ADX chassis devices"
"Matching LEDs to locations on ServerIron ADX chassis device modules"
outlines the LEDs for the ServerIron ADX 1000, including possible states and meanings.
Meaning
A link is established with the remote port (no traffic).
NOTE: There is one LED per port. Refer to
ADX 1000"
The port is transmitting and receiving packets.
A link is not established with the remote port and no traffic is being transmitted or
received.
A link is established with the remote port.
A link is not established with the remote port.
"Matching LEDs to locations on the ServerIron
on page 44 for information on matching each LED to the correct port.
Brocade ServerIron ADX Installation Guide
53-1002066-01