Functions; General Information - Siemens sitrans tr200 Operating Instructions Manual

Functions

8.1

General information

You can operate the SITRANS TR300 using either the SIMATIC PDM parameterization
software or the HART communicator. You can operate the SITRANS TR200 using the
SIMATIC PDM parameterization software.
The following functions are available to you when operating the SITRANS TR300/TR200:
● Identification
● Device data; this information is read-only
● Information about the measuring procedure
● Information on measurement interface
● Information about the output signal
● Certificates and approvals
SITRANS TR200/TR300
Operating Instructions, 04/2007, A5E01071992-01
– Information on operational safety: Day, description, message, assembly number
– Manufacturer and product name
– Order number, device serial number
– Revision numbers for the firmware and hardware revision
– Sensor class and sensor type, e.g. Pt100 resistance thermometer or thermocouple
type B
– Sensor factor
– Sensor characteristic curve, e.g. linear temperature
– Measuring range and measuring unit
– Type of interface: standard, differential or mean value circuit
– Type of connection/sensor connection: two-wire, three-wire or four-wire connection
with resistance-type transmitters
– Resistors for line compensation
– Offset to the measuring signal
– Additional information for the cold junction in thermocouples: internal, external or fixed
– Enable/disable the broken wire or short circuit test
– Filter time constant for noise suppression attenuation
– Output limit values: alarm and saturation limits
8
37