How To Adjust The Lens Position To The Left Or Right; Status Function; Automatic Adjustment (Auto Setup); Using The Shutter Function - Panasonic PT-D4000U Operating Instructions Manual

How to adjust the lens
position to the left or right
When the lens left/right adjustment dial is turned
clockwise, the screen moves toward the left;
conversely, when it is turned counterclockwise, it
moves toward the right. The maximum travel
distance toward the left or right is about 10 % of
the projection screen width.
The screen
moves toward
the right
• Move the lens left/right adjustment dial
Attention
to any position up to the maximum
adjustment position to make the
adjustment. Turning the dial with undue
force may cause malfunctioning.

Status function

This shows the projector status. It can also be used to
send information about the projector's status via E-
mail.
Press the STATUS button on the remote
control.
STATUS
INPUT
PROJECTOR RUNTIME
LAMP1
LAMP2
INTAKE-AIR TEMP.
OPTICS MODULE TEMP.
TEMP. AROUND LAMP
MAIN VERSION
NETWORK VERSION
REMOTE2
SEND STATUS VIA E-MAIL
EXIT
The screen
moves toward
the left
Lens left/right
adjustment dial
Maximum
adjustment
position
XGA60 RGB1
48.36kHz/60.00Hz
33h
13h/ ON/
13h/ ON/
25 ° C / 77 ° F
37 ° C / 98 ° F
37 ° C / 98 ° F
1.00.00
1.00
DISABLE
Automatic adjustment
(AUTO SETUP)
Automatic adjustment function adjust the resolution,
clock phase and image position automatically when
dots-structured analog RGB signals such as computer
signal are supplied. (Automatic adjustment is not
available if moving picture input signals or signals
having a dot clock frequency of more than 150 MHz
are supplied.) When DVI signals are input, the image
position is adjusted automatically.
It is recommended to supply images with a bright white
frame at the outermost periphery containing characters
etc. that are clear in white and black contrast when the
system is in automatic adjustment mode. Avoid
supplying images that involve halftones or gradation
such as photographs and computer graphics.
• "CLOCK PHASE" may have been shifted
Note
even when the adjustment ended
normally. In this case, manually adjust the
"CLOCK PHASE".
• Automatic adjustments cannot be
performed when images with blurred
edges or dark images are input.
With Composite sync and G-SYNC sync
signals and some types of PCs, it may not
be possible to perform these automatic
adjustments.
In this case, manually adjust the items of
"INPUT RESOLUTION", "CLOCK PHASE"
and "SHIFT".
• Image may be disturbed for about 4
seconds during automatic adjustment,
which is not an abnormal error.

Using the SHUTTER function

If the projector is not going to be used for a certain
period of time such as while a meeting is on a break or
preparations are being made, the mechanical shutter
can be used to hide the images temporarily.
Press the SHUTTER button of the
remote control or the main unit.
The image is turned off.
Press the SHUTTER button again.
The image comes back.
25