Projection; Powering Up The Projector; Making Adjustment And Selection - Panasonic PT-D4000U Operating Instructions Manual

Projection

Powering up the projector

When using an optional lens, install a projection
lens before powering up the projector. (Refer to
page 24.)
Remove the lens cover beforehand.
Connect the supplied power cord.
(120 V AC, 50 Hz/60 Hz)
Press the " I " marked side of the MAIN
POWER switch to turn on the power.
The power indicator lights up red, and the projector is
placed in the standby mode.
Press the " I " button. [on the main unit
or the remote control]
The power indicator illuminates in green and soon
the image is projected on the screen.
• If the projector is powered up at about 0 ˚C,
Note
a warm-up period of approximately five
minutes may be necessary to start
projection.
The temperature monitor (TEMP) lights
during the warm-up period.
When the warm-up is completed, the
temperature monitor (TEMP) turns off and
the image is projected on the screen.
• If the surrounding temperature is very low
and the warm-up period exceeds five
minutes, the control determines it as an
abnormal condition and turns off the
power automatically. If this happens, raise
the surrounding temperature to 0 °C or
higher and then turn the main power "on"
and turn the power "on" ( | ).
22
R/P G/Y B/P SYNC/HD VD
R B
S-VIDEO IN
VIDEO IN RGB 1 IN
REMOTE 1 REMOTE 2 IN IN SE
IN OUT
Making adjustment and
selection
It is recommended that the projector be allowed to
warm up for at least 30 minutes before any
adjustments are made to the focus.
<Using the remote control>
Press the FOCUS button to roughly
adjust the focus of the lens.*
Set the projection scheme in
"INSTALLATION" setting. (page 34)
Select the input signal by pressing the
input selector button to toggle through
RGB1, RGB2, VIDEO, S-VIDEO and DVI-D.
Turn the feet, and adjust the tilt of the
main unit in the front and rear or left
and right.
Use the lens left/right adjustment dial to
adjust the direction of the lens. (page 25)
Press the SHIFT button to adjust the
"SHIFT".*
Press the AUTO SETUP button if the
input signal is RGB/DVI signal. (page 25)
Press the ZOOM button to fit the image
size to the screen size.*
Press the FOCUS button again to adjust
the "FOCUS".*
Press the ZOOM button again to adjust
the "ZOOM" and fit the image size to
the screen size.*
* When operating at the projector, please refer to page
24.