Keylock Security; Led Indications - Motorola APX6000 User Manual

Keylock Security

The APX VA's keylock secures the radio in the APX VA when the vehicle is left
unattended. To lock the radio into the APX VA, turn the security key clockwise.
The key should be removed after locking or unlocking the APX VA.

LED Indications

A light-emitting diode (LED), located within the Engage Button of the APX VA
(see Figure 13), indicate charging conditions and audio accessory
(microphone) operating modes.
LED Indication
LED not lit
Solid RED
Flashing GREEN
Solid GREEN
Flashing RED
Flashing AMBER
Alternating RED/GREEN
Alternating AMBER/GREEN
(during first 4 seconds after
insertion and during charge
complete)
Solid PURPLE
Note: 1. A portable radio battery may not quickly recharge in the APX VA if the
battery is very hot or cold. To maximize battery life, and to avoid
charger LED indication flashing AMBER (rapid-charging paused),
avoid leaving your radio in a very hot or cold vehicle.
2. The unit has a label, which explains the LED indications. Another
label is supplied in the Console Kit that allows the user to place to
ensure visibility based on installation configuration.
3. All references to LED indication assumes that Surveillance Mode has
been disabled.
Normal (with radio not fully inserted into APX VA) or ignition off
(in most installations), or in covert mode.
Rapid charging; radio in APX VA.
Rapid charge complete; radio in APX VA.
Charge complete; radio in APX VA
A charging fault condition exists; check radio battery and its
charging contacts. If the fault condition continues, contact your
local Motorola representative for assistance.
Radio battery temperature out-of-range. Allow time for the
battery to cool down or warm up.
Battery end-of-service indication
Battery need re-calibration/reconditioning
Audio Accessory Error
• No microphone connected.
• Incompatible microphone connected.
• Microphone connected or disconnected after the radio is
inserted in the APX VA and turned on.
Description
35