Optional External Speaker Installation - Motorola APX6000 User Manual

6. Dress the cable so that it does not obstruct any vehicle controls nor touch
any hot or moving parts of the engine.
7. Connect power cable plug P2 to console jack J2.
8. If the optional external speaker is being installed, connect speaker cable
plug P1 to console jack J1. Attach strain-relief S-hook (not provided) to
the console; crimp the S-hook with a pair of pliers.
9. Connect external antenna cable plug P3 to console jack J3. If your model
has a mini-UHF type connector, use Mini-UHF Connector Tool (part
number REX4584) to tighten the connector.
10. Connect microphone cable plug P4 to console jack J4. Attach a strain-
relief
S-hook (not provided) to the console; crimp the S-hook with a pair of
pliers (Required when a hand microphone is installed.)
11. Make certain that no radio is installed in the console, and then replace the
two cable wire 5-amp fuses.

Optional External Speaker Installation

10-16 x 5/8"
Self-Tapping
Screw
24
0.157" (0.399cm)
Diameter
Figure 9: External Speaker Installation Detail
Dashboard
Firewall
Console Floor
Dashboard
Firewall
Trunnion Bracket
Trunnion Bracket
10-16 x 5/8"
Self-Tapping
Screw