Motorola APX6000 User Manual page 24

VEHICLE
CHASSIS
13.8 VOLT
VEHICLE
BATTERY
A+
FUSE
OR
BOX
SWITCHED
VEHICLE
A+
ANTENNA
OPTIONAL
SPEAKER
MOBILE
MICROPHONE
1. After setting the 2-foot (61 cm) section of the main power cable's red lead
aside for later use, route the main power cable through the firewall and
into the vehicle battery area. Use an existing opening or, if necessary, drill
a 3/8-inch (1 cm) hole through the firewall. Insert a grommet (not
provided) into the hole to prevent damage to the power cable.
Important Note: Failure to mount the red lead of the power cable kit
directly to the battery may result in severe alternator whine interference.
If severe alternator whine interference is present when the power cable
is properly installed, a power line filter kit, TLN5277, can be purchased to
reduce the interference.
2. Connect the supply cable wires as shown in the following table.
22
RED
5-AMP
BLADE-TYPE
FUSE
GROMMET
FIREWALL
YELLOW
5-AMP
BLADE-TYPE
FUSE
BLACK
Figure 8: Console Cabling