Microphone Bracket Location; Visor Microphone Location; Antenna Location - Motorola APX6000 User Manual

• the hang-up location for the microphone.
• the microphone's coil cord length (extended) during operation.
• the operability of the radio's controls while it is in the console.
• a substantial structure for accepting mounting screws.
• the speaker mounting location and cable length.
When possible, mount the console on the floor near the center of the vehicle
within easy reach of the operator.
• Do not reuse trunnion ("U") bracket hardware (screws)
from a legacy product.
• Do use the trunnion ("U") bracket hardware (screws)

Microphone Bracket Location

When possible, mount the microphone bracket on the dash near the operator
side of the console. The location should be within easy reach of the operator,
and it should be convenient to remove and hang-up the microphone in its
mounting bracket without interfering with any of the vehicle controls.
Do not attach the microphone bracket to the console housing.

Visor Microphone Location

The hands-free visor microphone is designed to clip onto the vehicle's sun
visor.
Note: When connecting the Visor Microphone (RMN5054) to the APX VA, do
not connect any wire of the Visor Microphone to pin 17 of Connector J1
on the APX VA. The instructions to do this in the IMPRES Visor
Microphone User Guide do not apply to the APX VA product. Two other
wires should be connected to pins 1 and 23 as instructed.

Antenna Location

Follow the guidance given in the Antenna Installation section of this manual to
ensure compliance with RF Exposure standards.
14
provided with the APX VA kit.