Kyocera ECOSYS P5021cdn Operation Manual page 176

Troubleshooting > Troubleshooting
Symptom
Printouts are curled.
Cannot print.
Cannot print with USB
memory.
USB memory not
recognized.
While "Auto-IP" is set to
[On], the IP address is not
assigned automatically.
The machine is emitting
steam in the area around the
paper ejection slot.
Checkpoints
―
Is the paper damp?
Is the machine plugged in?
Is the machine powered on?
Are the USB cable and network cable
connected?
Is the USB host blocked?
—
Is a value other than "0.0.0.0" entered
for the IP address of TCP/IP(v4)?
Check the room temperature to see if it
is low, or if damp paper was used.
Corrective Actions
Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Plug the power cord into an AC outlet.
Turn on the power switch.
Connect the correct USB cable and
network cable securely.
Select [Unblock] in the USB host
settings.
Check that the USB memory is securely
plugged into the machine.
Enter "0.0.0.0" for the IP address of
TCP/IP(v4).
Depending on the printing environment
and the paper's condition, the heat
generated during printing will cause the
moisture in the paper to evaporate, and
the steam emitted may look like smoke.
This is not a problem, and you can
continue printing. If the steam concerns
you, raise the room temperature, or
replace the paper with a newer, dryer
paper.
8-8
Reference
Page
page 3-2
page 3-2
—
page 2-9
page 2-7
page 6-22
—
page 2-17
—