Loosen Wheel Nuts; Put The Jack In Place; Raising The Car - Hyundai 2003 Sonata Owner's Manual

D060D02A-AAT

3. Loosen Wheel Nuts

The wheel nuts should be loosened slightly
before raising the car. To loosen the nuts, turn
the wrench handle counterclockwise. When
doing this, be sure that the socket is seated
completely over the nut so it cannot slip off. For
maximum leverage, position the wrench so the
handle is to the left as shown in the drawing.
Then, while holding the wrench near the end of
the handle, push down on it with steady pres-
sure. Do not remove the nuts at this time. Just
loosen them about one-half turn.
D060E01A-AAT

4. Put the Jack in Place

D060D01Y
The base of the jack should be placed on firm,
level ground. The jack should be positioned as
shown in the drawing.
WHAT TO DO IN AN EMERGENCY
D060F02E-AAT

5. Raising the Car

Wheel nut wrench
HEF-111A
After inserting a bar into the wheel nut wrench,
install the bar into the jack as shown in the
drawing. To raise the vehicle, turn the wheel nut
wrench clockwise. As the jack begins to raise
the vehicle, double check that it is properly
positioned and will not slip. If the jack is on soft
ground or sand, place a board, brick, flat stone
or other object under the base of the jack to keep
it from sinking.
Raise the car high enough so that the fully
inflated spare tire can be installed. To do this,
you will need more ground clearance than is
required to remove the flat tire.
3- 7
Wrench bar
HFC4022