Selecting Preset Stations; How To Preset Stations - Subaru 2000 Forester Owner's Manual

Audio
J Automatic tuning (SCN)
Press the "SCN" button to change the radio to the SCAN mode. In this
mode, the radio scans through the radio band until a station is found.
The radio will stop at the station for five seconds while displaying the fre-
quency, after which scanning will continue until the entire band has been
scanned from the low end to the high end.
Press the "SCN" button again to cancel the SCAN mode and to stop on
any displayed frequency.
When the "SCN" button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
Automatic tuning may not function properly if the station reception is
weakened by distance from the station or proximity to tall buildings and
hills.
J Selecting preset stations
Presetting a station with a preset button allows you to select that station
in a single operation. Up to six AM and FM stations each may be preset.
J How to preset stations
1. Press the FM/AM selection switch to select either FM or AM reception.
2. Press the "SCN" button or tune the radio manually until the desired
station frequency is displayed.
3. Press one of the preset buttons for at least two seconds to store the
frequency. The frequency of the station will flash once on the display at
this time. If the button is pressed for less than two seconds, the preced-
ing selection will remain in memory.
NOTE
If the connection between the radio and battery is broken for any
reason such as vehicle maintenance or radio removal, all stations
stored in the preset buttons are cleared. If this occurs, it is neces-
sary to reset the preset buttons.
– CONTINUED –
5-9