The Radio: Manual Tuning - Panasonic RX-EX1 Operating Instructions Manual

1
PGM
1
PGM
1
PGM
1
PGM
Auto
scan
1
PGM
1
PGM
FM AM
4 5 6 10
1
PGM
7 8 9 0
CD PLAY
C - RESET FM MODE BP
AUTO SCAN
MODE
CLOCK
TAPE TUNER CD
TIMER
P
FADER SLEEP EQ ON
- REC
REC ALL 1 ST
RANDOM MONO
FADER SLEEP EQ ON
- REC
REC ALL 1 ST
RANDOM MONO
FADER SLEEP EQ ON
- REC
REC ALL 1 ST
RANDOM MONO
FADER SLEEP EQ ON
- REC
REC ALL 1 ST
RANDOM MONO
FADER SLEEP EQ ON
- REC
REC ALL 1
RANDOM
MONO
SLEEP
FADER EQ ON
ALL 1 - REC
REC
RANDOM MONO
FADER SLEEP EQ ON
- REC
REC ALL 1 ST
RANDOM MONO

The Radio: manual tuning

Press [POWER,
Press [TUNER BAND] to select FM or AM.
Each time the button is pressed: AM
Press [TUNE MODE] to select the manual tun-
ing mode.
Make sure that " " is not displayed.
Press [REW/–/ ] or [
station.
" " is displayed during FM stereo broadcasts.
Turn [– VOLUME
" " " " "
Auto-tuning
Press and hold [REW/–/
quency starts changing rapidly.
Stops when it finds a station. (Interference may also cause
it to stop. Start auto-tuning again if this occurs.)
To stop auto-tuning
Press [REW/–/ ] or [
Using auto scan
Remote control only
You can search for a station by listening to all tuned-in
stations for 8 seconds each.
Press [TUNER] to select "FM" or "AM".
1
Press [AUTO SCAN].
2
Auto scan starts.
Press [AUTO SCAN] when you find the de-
3
sired station.
Auto scan ends when it reaches the original frequency again.
To stop during the process, press [AUTO SCAN].
To improve reception
FM: Change the length and position of the antenna.
AM: Change the facing of the unit.
•AM reception is briefly interrupted if a tape deck is operated.
•To improve reception when using the unit in a building or
vehicle use it near a window.
If noise is excessive in FM
Remote control only
Press [FM MODE/BP] to display "
Monaural sound is selected ("
duces when reception is weak.
Press [FM MODE/BP] again to cancel the mode.
To receive FM broadcasts allocated in 0.1MHz
Main unit only
First press [TUNER BAND] to select "AM". Now, press and
hold [TUNER BAND]. The display changes in a few sec-
onds to show the current lowest FM frequency. Continue to
hold down the button.
The minimum frequency changes and the step is changed at
the same time. Changing the step erases all preset stations.
Repeat the above to change the step back.
] to turn the unit on.
FM
/+/FF] to select a
+] to adjust the volume.
# # # # #
] or [ /+/FF] until the fre-
/+/FF].
".
MONO
" goes off) and noise re-
13
RQT5671