Listening To The Radio - Panasonic RX-ES50 Operating Instructions Manual

Listening to the Radio
CD/TUNE/TIME
-g
BAND
POWER
Press POWER.
(Only when the batteries are used for the power supply)
1
BAND
mmmmwm
Press BAND to display "LW",
"MW" or "FM".
LW—>MW—»FM
t_I
(The display changes each time the but¬
ton is pressed.)
[For Australia and New Zealand j
Press BAND to display "AM"
or "FM".
AM—»FM
t_I
(The display changes each time the but¬
ton is pressed.)
F M
8150
FM MODE/BP
o
Adjust the antenna.
[AM(LW/MW)1
comiNerriME
Press
►►!/+
or m/-
(TUNING + or — on the remote
control) to select the station.
NN/+: The frequency is increased.
K*/-: The frequency is reduced.
Automatic tuning:
Keep ►►{/+ or b4*/- depressed until
the frequency display starts to change. A
station with good reception is automati¬
cally selected and the selection process
then stops.
To stop automatic tuning, press ►►)/+
or m/— again.
F H
88
=.
"j
10
n
Lights when a station is
tuned in properly.
BE1E1
When the batteries are used for the power supply, pressing POWER
on the remote control cannot turn the unit on.
ITffiTI
• Pressing BAND will automatically turn the unit on and receive the
broadcasts which is previously tuned (only AC power is supplied),
•The automatic tuning may stop without a station having been tuned
in when interference is encountered on neighboring airwaves, In
such a case, tune in a station by tapping ►»/+ or NM/-.
• Radio broadcasts may be hard to receive in a moving vehicle or
building because their signals are weak. In such cases, use the unit
near by a window.
When FM stereo reception is too noisy
(Available only from the remote control)
Set the sound to the monaural mode to reduce the noise.
fm mode/bp
Press FM MODE/BP.
The I mono I display appears.
To return to stereo sound, press FM
MODE/BP again to turn off the I
mono
i
display.