Replacing An Auxiliary Light Bulb - Yamaha 2007 YZF-R1W Owner's Manual

3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove panel C (if replacing the
left auxiliary light bulb) or panel D
(if replacing the right auxiliary light
bulb). (See page 6-6.)
2. Remove the auxiliary light bulb
cover by removing the quick fas-
tener.
NOTE:
Remove the quick fastener by pushing
the center pin in with a screwdriver,
then pulling the fastener out.
1. Auxiliary light bulb cover
2. Quick fastener
6-38
EAU33910 3. Remove the socket (together with
the bulb) by pulling it out.
1. Auxiliary light bulb socket
4. Remove the defective bulb by pull-
ing it out.
1. Auxiliary light bulb
5. Insert a new bulb into the socket.
6. Install the socket (together with the
bulb) by pushing it in.
6