Cleaning And Lubricating The Drive Chain; Checking And Lubricating The Cables - Yamaha 2011 WR250X Owner's Manual

Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Clean the drive chain with kero-
sene and a small soft brush.
NOTICE: To prevent damaging
the O-rings, do not clean the
drive chain with steam cleaners,
high-pressure washers or inap-
propriate solvents.
[ECA11121]
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant. NOTICE: Do not use
engine oil or any other lubri-
cants for the drive chain, as they
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU23025 may contain substances that
could damage
[ECA11111]
ECA10583
Checking and lubricating the
the O-rings.
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
WARNING! Damage to the outer
sheath may interfere with proper ca-
ble operation and will cause the in-
ner
damaged cable as soon as possible
to prevent unsafe conditions.
7-27
cable to rust. Replace
Recommended lubricant:
Engine oil
EAU23101
a
[EWA10721]
7