ABB Freelance 2000 Manual page 68

Section C
Export on event
Reexport
Access manually
export
Target
Station
Gross Automation, 1725 South Johnson Road, New Berlin, WI 53146, www.ssacsales.com, 800-349-5827
C-24
Data transfer takes place as a function of the state of the entered
event module. It is compulsory to input an event module.
With function key F2 a selection list appears.
No event-controlled data transfer.
on every event
Data transfer will occur only in case an event flank increases.
cyclic every
Data transfer will occur only when an event flank increases. From this
period on, the data transfer will be effected cyclically as long as the
event is current.
Which time periods the data transfer should follow are determined
here. Make entry in the TIME format.
incremental
Only the data acquisitioned since the last data transfer are transmit-
ted.
complete
All archived data are transmitted.
The operator at the operator station can enable file transfer.
File transfer cannot be enabled manually.
Here the target of the file transfer must be defined. As target a PC in
the Freelance 2000 net can be used; it must feature a network card and
an installed TCP/IP license. Ideally, the supplementary package Digi-
Browse should be installed on this PC to permit visualization of archive
files of the trend and of logs.
Specification of the IP Address of the target computer.
If you are operating your Freelance 2000 system in a network, you
should obtain the IP addresses from your network manager, because this
address must be selected unambiguously worldwide. If you want to
use the DigiVis PC as file transfer target, its IP address must be
given here.
Standard Displays