Setting An Indoor Unit Address And Installation Option; Troubleshooting - Samsung AC035FCADEH/EU Service Manual

4. Troubleshooting

4-1 Setting an indoor unit address and installation option

▶ Set the indoor unit address and installation option with remote controller option.
Set the each option separately since you cannot set the ADDRESS setting and indoor unit installation setting option at the
same time.You need to set twice when setting indoor unit address and installation option.
▶ Please use the proper wireless remocon which can set 24 digit option code. Following is the instructions of setting option
code with wireless remocon of MR-DH00. (MR-AH01 can be used for operating but cannot be used for setting the installation
option because only 12 digit option setting is available.
▶ Please refer to the wired remocon installation manual for setting with the wired remocon.
4-1-1 The procedure of setting option
Step 1. Entering mode to set option
1. Remove batteries from the remote controller.
2. Insert batteries and enter the option setting mode while pressing High Temp button and Low Temp button.
3. Check if you have entered the option setting status.
Step 2. The procedure of option setting
After entering the option setting status, select the option as listed below.
Option setting is available from SEG1 to SEG 24
previous other remocons.
For example : SEG2, 3
SEG 21, 22
SEG1 SEG2 SEG3
0 X X
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18 SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
2 X X
4-1
Entering mode for
setting option
High Temp Button
Low Temp Button
SEG4, 5 SEG6, 8
SEG23, 24.
SEG4 SEG5 SEG6 SEG7
X X X 1
X X X 3
Option setting mode
SEG9, 10 SEG11, 12
SEG8 SEG9 SEG10 SEG11 SEG12
X X X X X
X X X X X
Mode change
High Fan Button
Low Fan Button
SEG 14, 15 SEG 16, 17
On(SEG1~12) Off(SEG13~24)
Samsung Electronics
SEG 18, 20