Using The Display - Panasonic CF-18 Series Reference Manual

Standby/Hibernation Functions

Using the Display

Entering the standby or hibernation mode
1
Slide the power switch (A); at the beep
The computer will enter either the standby or hibernation mode, depending on the
setting.
CAUTION
After releasing your finger from the power switch, do not touch the power switch until
the power indicator goes off or blinks.
*1
At the beep sound, release your finger from the power switch. If you continue to
slide the power switch and hold it for more than four seconds, the computer will emit a
*1
second beep then power off. Data not previously saved will be lost.
Even when [When I press the power button on my computer] is set to [Shut down] with
[start] - [Control Panel] - [Performance and Maintenance] - [Power Options] -
[Advanced], if you slide the power switch for more than four seconds and do not
release it, a second beep
not previously saved will be lost.
*1
When the speaker function is disabled, e.g., by the key combination
sound.
Setting
1
Select [start] - [Control Panel] - [Performance and Maintenance] -
[Power Options] - [Advanced].
2
Select [Stand by] or [Hibernate] for [When I close the lid of my
portable computer], and then select [OK].
Entering the standby or hibernation mode
1
Close the display.
*1
will sound and the power will be turned off forcibly. Data
39
*1
sound, release your finger.
Fn F4
+ , there will be no beep