Toyota 2009 Camry Quick Reference Manual page 289

3-6. Other interior features
Programming a Rolling Code system (for U.S. owners)
n
If your device is Rolling Code equipped, follow the steps under the
heading "Programming HomeLink
steps listed below.
STEP 1
Locate the training button on the ceiling-mounted garage door
opener motor. The exact location and color of the button may
vary by brand of garage door opener.
Refer to the operation manual supplied with the garage door opener
for the location of the training button.
STEP 2
Press the training button.
STEP 3
Press and release the vehicle's programmed HomeLink
ton twice. The garage door may open.
If the garage door opens, the programming process is complete. If
the door does not open, press and release the button a third time.
This third press and release will complete the programming process
by opening the garage door.
The ceiling-mounted garage door opener motor should now recog-
nize the HomeLink
STEP 4
Repeat the steps above to program another rolling code sys-
tem for any of the remaining HomeLink
n Programming an entry gate (for U.S. owners)/Programming all
devices in the Canadian market
STEP 1
Place your transmitter 1 to 3 in. (25 to 75 mm) away from the
surface of HomeLink
Keep the indicator light on HomeLink
STEP 2
Press and hold the selected HomeLink
STEP 3
Repeatedly press and release (cycle) the device's remote
control button for two seconds each until step 4 is complete.
STEP 4
When the indicator light on the HomeLink
ceiver starts to flash rapidly, release the buttons.
266
®
" before proceeding with the
®
transceiver and operate the garage door.
®
.
®
buttons.
®
in view while programming.
®
button.
®
compatible trans-
®
but-