Using The Downdraft System; Using The Controls - GE JVB67 Owner's Manual & Installation Instructions

Using the downdraft system.

On some models, the RAISE/LOWER
switch is located at the top right of
the vent.
Use the selector switch to turn the
blower ON, OFF or to change the
blower speed.
RAISE/LOWER Switch
(30" models only)
Turn the downdraft blower ON by pressing
the RAISE/LOWER switch located at the top
right of the vent (on some models). Place
your finger on the "center" of the switch
and hold until you observe the vent moving,
then release. The air vent will rise. Use the
selector switch to turn the blower ON, OFF
or to change the blower speed.
The vent may be lowered by again pressing
the RAISE/LOWER switch at the top right side
of the vent. The blower, if left on, will
automatically go off when the vent is
lowered.
NOTE: For most convenient operation, set the
blower to the speed you use most often. The
blower will come on to this speed whenever
the unit is raised.
Using the Cooktop
Caution
Be careful when raising or lowering the
downdraft. Be sure pots, pot handles and
other objects are clear of the downdraft and
cannot be struck or tipped by the downdraft
being raised.
NOTE: There is a slight trim overhang at each
end of the vent.
To avoid injury, be sure fingers are clear
of the downdraft cover when it is being
lowered.
Keep hands and fingers away from all
downdraft parts.
Remote RAISE/LOWER switch
(36" models only)
36" models have a remote RAISE/LOWER
switch. It operates in the same manner as
the switch located on the vent.
RAISE/LOWER switch location may vary.
5