How To Install Filter - Coway AP-3008FH Instructions Manual

PREPARATIOnS

how to install filter

- Make sure to remove each filter's plastic packaging before installing the filters.
- Select the product model depending on your requirements.
- Use the product only within a single room.
- When the unit is not in use, disconnect the power plug from the electric outlet.
Tips
- Check the front part of the filter when installing it.
▶
The filter order: Pre-filter → Non-woven fabric filter → Custom filter →
1. Open the front cover.
Turn the lock at the bottom part of the product
counterclockwise while pressing it using a coin or
flat-head screwdriver, pull the front cover forwards,
and then lift the cover upwards to separate it.
2. Remove Remove the filter case.
Separate the first filter case from the product by
pressing the catches on both sides and pulling it
forwards. Separate the second filter case from the
product by pulling it forwards after removing the
top and bottom screws.
3. Remove the plastic packaging from the Custom,
Deodorization and hEPA filters and insert them
into the filter case in this order.
▶
4. Install the filter cases into the product and close the front cover.
∗ After installing the second filter case, make sure to fasten the top and bottom screws.
∗ After closing the front cover, close the lock at the bottom part of the product by turning it clockwise while pressing it.
Deodorization filter → HEPA filter
▶
▶
▶
▶
▶
▶
▶ ▶