Operation - Rowenta DH4130 User Manual

EN
START-UP OF THE APPLIANCE
Before using your appliance for the first time, check that the supply voltage matches that indicated
on the appliance.
Your appliance has to operate with an earthed plug. It is a class I appliance.
Before switching on your appliance, make sure that:
- the appliance is positioned in accordance with these instructions,
- the air inlet and outlet grills are completely unobstructed,
- the appliance is placed on a flat and stable surface.
- the tank float (8 Fig.1 - Safety instructions) moves freely in its housing.
Plug the lead in and press the start button (A).
On the display, the pictogram (L) appears indicating the temperature and relative humidity of the
room,
Your appliance starts up in continuous operation. You can also define the mode you want to use by
selecting the functions described in the following section.
After switching off using the OFF button (without unplugging), when the appliance is switched on it
automatically starts in the previous configuration.

OPERATION

• HUMIDITY CONTROL Function
To set the target relative humidity, select one of the values, 70%, 60% or 50%, using the button (B).
If the 70% function is selected, this means that the air will be dehumidified until the relative
humidity falls to 70%. The appliance with regulate automatically if the relative humidity is below
70% (the compressor will stop but the fan will continue to operate).
The compressor will start again if the relative humidity exceeds 70%.
The same applies if 60% or 50% is selected.
• CONTINUOUS Function
The unit dehumidifies the room continuously if the CONTINUOUS function (O) is activated using
button (B), regardless of the ambient humidity.
• SPEED Function
Press button (C) to select:
: gentle ventilation
: high ventilation
11