Installation Using The Wps Key (Repeater Mode); Manual Installation Through Web Interface - Supra WLR-510 Instruction Manual

UK IRL
22

Installation using the WPS key (repeater mode)

The quickest, easiest and reliable way to establish a wi-
reless connection between the repeater and the WLAN
router, is the WPS button.
NOTE!
This connection method requires both devices
to contain a WPS button. As factory setting, the
WPS button is set to 2.4G radio mode. To log-in
as a dual band router, whose WPS function is
activated in the 5G radio mode, the WPS button
of the Web Interface must first be set to the 5G
radio mode.
1. Hold down the WPS button on the repeater for at least
5 seconds.
2. After 5 seconds the Power/WPS LED flashes three
times.
3. The WPS function is now active and waits for the WPS
connection.
4. Next press the WPS button of your router to be
connected to the repeater. This step must be carried
out within two minutes. The connection is set up and
the network information is exchanged.
5. When the connection has been established, the Pow-
er/WPS LED is lit permanently.
6. If the Power/WPS LED flashes, a connection fault has
occurred. Wait two minutes until the LED is switched
off and restart the connection.
Start Start
7. The 5G and 2.4G signal LEDs show whether or not the
connection is fully set up.
8. Use the Web interface in order to call up the extended
settings after successful WPS connection or to ma-
nually establish the connection in case of a failed WPS
connection.
• After having restarted the repeater you can log into
the access point with your computer through the
repeater. The network detection is the same as the
SSID of the access point.
• The network key and the encoding are handled by
the router.

Manual installation through WEB interface

1. Connect the LAN connection of your computer to the
LAN socket of the repeater using the LAN cable. When
logging in as "Wi-Fi repeater" you can alternatively
use the WLAN interface of your computer. Search
amongst the available wireless networks for the
network "Wi-Fi repeater" and connect to the network.
Dismiss the Windows suggestion of setting up the
network through Windows Setup and select the opti-
on "Connect to network without setup".
2. Open your Web browser and enter IP address
"192.168.10.1".
3. The log-in window of the repeater appears. Enter the
default user name "admin" and the default password
"admin". Click on "Ok".
UK IRL
23