Logging Into The Web Interface - Supra WLR-510 Instruction Manual

UK IRL
24
4. Click on "Repeater" to start the assistant. All available
wireless 2.4G and 5G access points are listed.
5. Select the access point to which the repeater is to be
connected and click on "Continue".
NOTE!
If the desired Access Point is not listed, ensure
that it is active and place the repeater closer to
the Access Point. Next click on "Update" to re-
fresh the list of available wireless access points.
6. The log-in window for the selected access point
appears.
7. Enter the network key and click on "Continue".
8. To close down the Assistant and use the repeater in
the network, select the entry "Accept".
9. Wait a few seconds whilst the repeater restarts. After
having restarted the repeater you can log into the
access point from the list of available networks with
your computer and through the repeater.
NOTE!
By default, the network detection is the same as
the SSID of the access point to which the repea-
ter is connected. You can, however, also assign
a different network code.
Start The Web interface
The Web interface
The Web interface allows you to configure the repeater
and to, e.g. set up the WPS connection, if it could not be
set up.
Depending on the selected mode the appearance of the
Web Interface changes, as selection options relevant for
the selected operating mode are shown or hidden.

Logging into the Web interface

1. Enter the default user name "admin" and the default
password "admin". Click on "Ok".
2. The start page of the configuration menu of the WLAN
repeater opens. The contents of the individual menus
differ depending on which mode has been set on the
repeater.
Start page
The start page contains all information about the repea-
ter and its settings.
UK IRL
25