Cannon ICON 1000 Use And Installation Instructions page 19

COOKER FINISH
Vitreous Enamel
Hotplate, pan supports,
burner caps, roasting dish,
grill pan, oven base, rear and
roof, door inner panels, grill
compartment, control panel.
Paint
Side panels, central trim, end
caps.
Aluminium
Burner bodies..
Glass
Chromium Plating
Oven shelves, grill pan grid,
grill pan handle support
Plastic
Grill pan handle, control
knobs.
Hotplate Burners
Stainless Steel
Door trims, door handles,
control knobs.
CARE AND CLEANING
CLEANING METHOD
Cloth wrung out in warm soapy water. Stubborn
stains can be removed with a cream paste,
liquid cleaner or by rubbing with fine steel wool
soap pads e.g. Brillo, Ajax.
Check that the cleaning agent is approved by the
Vitreous Enamel Association.
Wash with a cloth wrung out in warm soapy water
only.
DO NOT USE ABRASIVE CLEANERS / POWDERS OR
SCOURING PADS WHICH MAY SCRATCH THE SURFACE.
Similar to paint cleaning above. Use a nylon brush to
remove any cleaning materials, water or dirt from
the hotplate burner ports. Care should be taken
when refitting the bodies over the electrodes.
As for enamel cleaning. Polish with a clean dry cloth
or kitchen roll.
Wipe with a cloth wrung out in warm soapy water.
A fine steel wool soap pad e.g. Brillo, Ajax, or a
chrome or stainless steel cleaner may be used.
Wipe with a cloth wrung out in warm soapy water.
Stubborn stains can be removed with a cream
cleaner.
To ensure rapid lighting of the hotplate burners
every time they are used, the electrodes must be
kept clean and dry. Remove any food spillage or
cleaning materials from the electrode using a small
nylon brush such as a toothbrush.
Wipe with a cloth wrung out in warm soapy water.
Do not use chlorine based cleaners.
19