Service; Maintenance; Ash Removal - Jøtul F 165 Installation And Operating Instructions Manual

ENGLISH

5.2 Ash removal

Jøtul F 164 / F 165 / F 166 / F 167 have an ash pan which makes
it easy to remove the ash.
Fig. 12
1. Scrape the ash through the grate in the base plate and into
the ash pan. Use a glove to grab the handle on the ash pan.
2. Make sure that the ash pan doesn't fill up so high that it keeps
ash from coming through the grate into the pan.

6.0 Service

Warning! Any unauthorised change to the product is not allowed.
Only use original spare parts.
6.1 Changing the burn plates/inner
bottom plate
Fig. 13
14
1. Lift the baffle (Fig. 13 A) up carefully.
2. Remove one of the side burn plates (Fig. 12 E) by lifting
them up a little and then out. (Be aware if using tools, that
vermiculite plates may be damaged by rough handling).
3. Remove the baffle.
4. Remove the other side burn plate.
5. Unscrew the M8x25 mm screw on the rear burn plate (Fig. 13
F) and remove the burn plate.
6. Then lift up and remove the inner bottom plate (Fig. 13 C).
Follow the same procedure for installation, but in the opposite
sequence.
6.2 Changing the baffle / deflectors
• Follow step 1 -3 under Fig. 13.
• Access is then easy to the smoke deflectors (Fig. 13 B) if they
need to be removed. They are situated on 1 knob on the side
and on the air manifold (fig. 13 D).
• Edge them down and remove them through the door.
For re-installation follow the same procedure in the opposite
sequence.

7.0 Maintenance

7.1 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
fireplace during use. Soot is a good insulator and will therefore
reduce the fireplace's heat output. If soot deposits accumulate
when using the product, they can easily be removed by using a
soot remover.
In order to prevent a water and tar layer from forming in the
fireplace, you should regularly allow the fire to burn hot in order
to remove the layer. An annual internal cleaning is necessary to
get the best heating effect from your product. It is a good idea
to do this when cleaning the chimney and flue pipes.
7.2 Sweeping flue pipes to the chimney
Flue pipes must be swept through the flue pipe sweeping hatch
or through the door opening.
One of the baffles will have to be removed first in order to do this.