Omron BU5002RWLG User Manual page 33

(2) Attach the terminal block cover (with cable clamp) to the unit.For BU2002RWLG and BU3002R-
WLG, attach the cover after connecting the input cable.
BU2002RWLG/BU3002RWLG
Insert the upper part of the terminal block cover into the slit of the unit, and tighten it with two of
the included M3 screws.
Tighten the cable clamp dial to stabilize the wire.
BU5002RWLG
Insert the tab on the left side of the terminal block cover into the slit of the input terminal block cov-
er, and then run one of the included M3 screws through the hole on the right side of the terminal
block cover and tighten it.
Tighten the cable clamp dial to stabilize the wire.
2-3-3. Connecting to a computer
When using the included UPS monitoring software or the contact signal, use the connection cable to
connect the unit to the PC.
"7. Using the UPS monitoring software and Contact Signal" on page 38.
See also
* If you do not use the UPS monitoring software and Contact Signal, this step is not required.
2002
BU RWLG/BU
OUTPUT
1φ 100/200/208/
INPUT
220/230/240 VAC
1φ 170-278 VAC
50-60 Hz 15 A
50-60 Hz 15 A
G L2
L1 G L2 L1
INPUT OUTPUT1 25 A
G L2 L2
L1 G L1
3002 5002
RWLG/BU RWLG
2
17