Arctic Cat Pantera 7000 xt ltd Operator's Manual page 60


NOTE: To access the harness con-
nector and the two self-tapping
screws securing the taillight to the
snowflap, compress the two flanged
tabs (located on the under-side of
the tunnel) and carefully pry up on
the front of the taillight/snowflap.
1. Disconnect the taillight harness con-
nector.
2. Remove the two self-tapping screws
securing the taillight to the snowflap.
3. Secure the taillight to the snowflap
with the two self-tapping screws;
then connect the taillight connector.
4. Secure the front of the snowflap to
the tunnel by carefully tapping the
snowflap until the two flanged tabs
snap into place.
Bearcat 2000 LT/Lynx LT
1. Remove the torx-head cap screws
securing the taillight access panel.
2. Disconnect the harness connector
and remove housing.
3. Push in on the socket and rotate it
counterclockwise to remove it from
the housing.
4. Remove the old bulb by pulling it
straight out of the socket.
56
5. Install the new bulb in the socket by
pushing it straight in.
6. Push the socket into the housing and
rotate it clockwise to lock into place.
7. Connect the harness connector.
8. Secure the access panel with the
torx-head cap screws.
Bearcat 2000 XT/XTE
1. Remove the four pins securing the
rear seat to the seat/Speedrack mount.
0744-462
2. Lift on the back of the rear seat and
move rearward to remove it from the
mount.
3. Compress the latch on the right side
of the front seat and lift the front seat
away; then disconnect the taillight
harness connector.
4. Loosen (but do not remove) the
three
mount cap screws.
742-467A
5. Carefully route the harness connec-
tor through the hole in the storage
compartment panel; then remove the
harness from beneath the seat/Spee-
drack mount.
6. Remove the two self-tapping screws
securing the taillight to the bumper;
then route the harness out of the
bumper and remove the taillight.
right-side seat/Speedrack
743-329A
743-444A