Securing The Band To The Cylinder - Aqua Lung Balance User Manual

SECURING THE BAND TO THE CYLINDER

NOTE: BC cylinder bands adjust for all standard cylinder diameters: 6.9 in (17.5 cm), 7.25
in (18.5 cm), and 8.0 in (20.3 cm). The cylinder bands are properly threaded to the buckles
when the BC leaves the factory. If rethreading is necessary, follow the procedure in the section:
Threading the Cylinder Band.
WARNING: The cylinder band will initially stretch as it becomes wet. Always wet the band
before making the final adjustment; apply enough tension to ensure that the cylinder is
completely secure. Test this connection before every dive. If the cylinder slips free from
the BC during the dive, you may loose your air supply, which could lead to serious injury
or death.
NOTE: Your BC may come equipped with a tank positioning strap. This strap allows you to place
the BC in the proper position for perfect tank placement. Place the tank positioning strap over the
cylinder valve and adjust as needed.
1. Remove the free end of the cylinder band from
the outer slot on the buckle.
2. Wet the cylinder band and then slide it over the cylinder so that the BC is at the desired position in
relation to the cylinder valve. Make sure the cylinder valve air outlet is facing the back of the BC.
BC
Home
© 2012 Aqua Lung International
English