Circulating-Air Mode; Replacing The Led Lights; If You Encounter A Problem - Gaggenau AC 250 Instruction Manual

Aluminium and plastic surfaces:

Do not use dry cloths.

Use a mild window cleaning agent.

Do not use aggressive, acid or caustic cleaners.
Observe the warranty regulations in the enclosed service booklet.

Replacing the LED lights

Defective LED lights must only be replaced by the manufacturer, their
customer service department or a licensed technician (electrician).

If you encounter a problem

If a or appears in the display:
 See "Filters and Maintenance" Section.
If it is not possible to operate the extractor hood:

Disconnect the extractor hood from the mains electricity supply
by pulling out the plug or switching it off at the main fuse box.
Wait for approx. 1 Minute and then switch it on again.
If the lights of the lamps is weak when the hood is in stand-by, then
invert the plug (invert phase with neutral).
If you have any questions or if a fault occurs, please call Customer
Service. (see list of Customer Service representatives).
When you call please quote the following:
E-Nr.
Enter the relevant numbers into the box above. The E-Nr. (Product
no.) and FD (Production date) are shown on the nameplace which
can be seen inside the extractor hood after the filter frame has been
detached.
The manufacturer of the extractor hood accepts no liability
for complaints which can be attributed to the design and layout
of the pipework.
12
FD

Circulating-air mode


An activated carbon filter circulating-air module must be fitted
for this operating mode
The complete installation set and replacement filters can be
obtained from specialist outlets. VIB: AA010810.

The extractor-hood fan extracts the kitchen vapours which are
purified in the grease filter and activated carbon filter and then
conveyed back into the kitchen.

The grease filter absorbs the grease particles in the kitchen
vapours.

The activated carbon filter binds the odorous substances.
If no activated carbon filter is installed, it is not possible to bind
the odorous substances in the cooking vapours.
Changing the electronic control systemto recirculating mode:

The standard factory setting is foroperation in exhaust-air mode.

To change the mode, the extractor hoodmust have been
connected up andshould be switched off.

Simultaneously press buttons O and
Then release thebuttons.

goes out shortly afterwards.The electronic control system will
thenhave been set to recirculating mode.

By repeating steps 1and 2, you canchange the electronic control
systemback to exhaust-air mode (
Caution:
As the filter becomes more and more saturated with grease, there is
an increased risk of fire and the function of the extractor hood may be
impaired.
Important:
Change the activated carbon filter promptly to prevent the risk of fire
from the accumulation of heat when deep-fat frying or roasting.
Saturation indicator:
When the activated carbon filter becomes saturated, the display
symbol lights up and a signal sounds. The signal is switched off
when the fan is switched off. The activated carbon filter should be
replaced straight away.
Replacing the activated carbon filter:

During normal operation (1 to 2 hours per day) the activated
carbon filters should be replaced approximately 1 x year.

A replacement filter can be obtained from any authorized dealer.

Use original filters only.
By doing so you will obtain maximum performance from your extractor
hood.
Disposing of the old activated carbon filter:

There are no pollutants in the activated carbon filters. They can
therefore be disposed of as part of your normal domestic refuse.
until comes on.
in display).