Dimplex DF2608-EU Owner's Manual page 8

Fireplace Installation
4. Use studs to frame an open-
ing of 680 mm wide X 585
mm high X 229 mm deep.
Option #1
The power cord can be run from
behind the trim and along the wall
to an outlet near the fireplace.
Option #2
A new outlet can be installed
inside the framing construc-
tion. Plug the fireplace into a 10
Amp/240 Volt outlet. If the cord
does not reach you may use a
3-core type extension cord rated
for a minimum of 10 Amps.
Existing Fireplace:
1. Seal all drafts and vents with
a non-fibrous insulation mate-
rial to prevent any chimney
debris from falling onto the
fireplace. Do not install into
an existing fireplace that is
prone to dampness.
2. Cap the top of the chimney
flue to prevent rain from
entering.
3. Plan your electric power sup-
ply.
4. The power cord can run along
the front of the hearth to an
outlet near the fireplace.
8
CAUTION: Clearance for
air circulation beneath the
fireplace insert is provided by
two spacers. Do not install
the fireplace insert directly
on carpet or similar sur-
faces which may restrict air
circulation . If installing the
fireplace in a carpeted area,
place a one-piece, solid, flat
surface under the fireplace
insert. Ensure that all three of
the insert's feet rest securely
on this surface.
www.dimplex.com