Morso 553 Installation Instructions
Panther
Hide thumbs
Also See for 553:
- Installation instructions manual (12 pages) ,
- Owner's manual (12 pages) ,
- Owner's manual (5 pages)
Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
morsø
PANTHER
GAS STOVE
MODEL NUMBER 553
Before installation ensure that the local distribution conditions (identification of the type of gas and
pressure) and the adjustment of the appliance are compatible
This is not a "Do It Yourself" product
This appliance must be installed by a competent person
These instructions must be left with the user
This appliance meets the requirements of the European Gas Directive
Manufactured by Morsø Jernstøberi A/S, Furvej 6, 7900 Nykøbing Mors, Denmark
Distributed by Wonderfire, Wood Lane, Erdington, Birmingham B24 9QP, England
600B476/02
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Morso 553
Summary of Contents for Morso 553
- Page 1 INSTALLATION INSTRUCTIONS morsø PANTHER GAS STOVE MODEL NUMBER 553 Before installation ensure that the local distribution conditions (identification of the type of gas and pressure) and the adjustment of the appliance are compatible This is not a “Do It Yourself” product...
- Page 2 As supplied, this appliance is for use with natural gas (G20) When converted using conversion kit no. 555311 this appliance is for use with propane gas (G31) This appliance is for use in the United Kingdom (GB) and the Republic of Ireland (IE) only. LIST OF COMPONENTS 1 Cast iron stove containing gas burner unit &...
- Page 3 Figure 1 • The flue must be swept before the appliance is installed. Ventilation: In the United Kingdom (GB) no special ventilation bricks or vents are required in the room for this appliance. In the Republic of Ireland (I.E.), permanent ventilation must comply with the regulations currently in force. Location: This appliance must not be installed in a private garage or any room, which contains a bath, or shower or where steam is regularly present.
- Page 4 FITTING THE CERAMIC FIREBOX WALLS & FUEL BED The windows are secured with a locking screw. Remove the screw with the Allen key supplied. See figure 2. Open the windows. Place the ceramic walls against the firebox sides. Locate the back edges of the walls in the tabs at the back corners of the firebox.
- Page 5 CHECK REFERENCE PRESSURE The burner aeration is non-adjustable. The appliance is pre-set to give the correct heat input on Natural Gas at 20 mbar (8in w.g) inlet pressure and no further adjustment is necessary. The burner pressure should be checked at the pressure test point located at the side of the control unit (See figure 9) .
Need help?
Do you have a question about the 553 and is the answer not in the manual?
Questions and answers