Connecting Onkyo Components; Connecting The Power Cord - Onkyo HT-S780 Instruction Manual

HT-S780_En.book Page 31 Monday, February 28, 2005 2:13 PM
Connecting Your Components —Continued
Connecting Onkyo
Step 1: Be sure that the Onkyo component is connected to the AV receiver with an analog audio cable (RCA).
Step 2: Make the
connection.
With (Remote Interactive) you can use the following special
Auto Power On/Standby
When you start playback on a component connected via
that component as the input source automatically. Similarly, when the AV receiver is set to Standby, all components
connected via will also enter Standby. This function will not work if a component's power cord is connected to the
AV receiver's AC OUTLET.
Direct Change
When playback is started on a component connected via
the input source. If the DVD player is connected to the AV receiver's multichannel input, you must press the
[MULTI CH] button (see page 35) to listen to all channels because the Direct Change
IN FRONT jacks.
Remote Control
You can control other -compatible Onkyo components by pointing the remote controller at the AV receiver's remote
control sensor. You must enter the appropriate remote control code first (page 53).
Notes:
• Use only cables for
cables are supplied with Onkyo players (DVD,
CD, etc.).
• Some components have two
connect either one to the AV receiver. The other is
for connecting additional
nents.
• Connect the AV receiver's
components. Connecting to other manufacturer's
components may cause them to malfunction.
• Some components may not support all
tions. Refer to the manuals supplied with your
components.

Connecting the Power Cord

Notes:
• Before connecting the power cords, connect all of your speakers and AV components.
• Turning on the AV receiver and subwoofer may cause a momentary power surge that might interfere with other
electrical equipment on the same circuit. If this is a problem, plug them into a different branch circuit.
Components
, if the AV receiver is in Standby, it will turn on and select
, the AV receiver automatically selects that component as
connections.
jacks, you can
REMOTE
CONTROL
-compatible compo-
jack to only Onkyo
func-
functions:
function selects only the DVD
e.g., CD player
e.g., DVD player
IN
L
R
CD
FRONT
L
R
DVD
R L
ANALOG
AUDIO OUT
R L
ANALOG
AUDIO OUT
31