To Turn The Fire Off - Baxi 741FS Owner's Manual

2. Keep the button at the ignition position for a further ten
seconds. This will prevent the flame-sensing device from
shutting off the gas while its probe warms up as explained
above.
3. If low heat is required, release the button. The button
will automatically spring up to the low heat position
shown in figure 2 (See note i below).
4. For a higher heat level slide the button upwards. The
burner flames and heat output will gradually increase
until the button reaches the high heat position shown in
figure 2. When the button reaches the high heat position
you will feel a check to its movement. Do not slide the
button above the high heat position unless you want to
turn the fire off (See note i below).
Note i) If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the fire serviced.
ii) Please note. When first turned on the flames will appear predominantly
blue. The fuel effect pieces will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only
be apparent after a somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon
deposits that may have formed during previous operations.
iv) If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits that
may form during operation.

To turn the fire off.

Slide the button up past the high heat position to the
"O" position.
Both the main burner and the pilot should go out.
While cooling, the ceramic fuel effect pieces may
make some crackling noises. This is quite normal.
Lighting with a taper.
See figure 3.
In the unlikely event of failure of the ignition spark,
the pilot can be lit by a taper or long spill. Insert the
taper or spill between the second and third left hand
ceramic fuel effect pieces on the first row. Operate the
OWNER GUIDE
Page 8
Figure 2. Control markings
Figure 3. Lighting with a taper