Advertisement
INSTALLER AND OWNER GUIDE
Moving the Cable Guide
At the base of the heater you will find the electric
cable which runs through a rectangular plastic cable
guide. The cable guide is fitted into the rectangular
slot on the right side of the heater. If required this
can be moved and put in the rectangular slot in the
centre or left hand side of the heater. For removal
and fitting please see below.
Removing the cable guide
1. Before moving the cable guide please note that the
lip of the cable guide is on the outer edge of the base
(See figure 1- Item 1).
2. To remove the cable guide push and lift the tab on
the bottom of it and the cable guide will open (See
figure 1- Item 2).
3. Lift the electric cable clear of the cable guide.
4. Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 1- Item 3).
Fitting the cable guide.
When fitting the cable guide please remember that
the lip of the cable guide
has to be fitted against the
outer face of the base (See
figure 1- Item 1).
1. Gently pinch the sides of
the cable guide (See figure
1 - Item 4) and push into
the desired rectangular slot.
2. Place the electrical cable
into the guide and close the
top.
If the mains cable is
damaged, to avoid a hazard
it must be replaced by a
Baxi fires division
authorised service agent, or
Figure 2. Removing the
fascia.
Page 6
Item 1
Item 2
Item 3
Item 4
Figure 1. Removing and
positioning the cable guide.
Advertisement
