Advertisement
INSTALLER AND OWNER GUIDE
glove is provided with the coal pack). It is not
necessary to use all the coal supplied. If the
coal pieces are too large then a suitable tool
can be used to break them.
Important Note:
The coals are for decorative purposes
only. There is a choke risk to young
children. Make sure they cannot gain
access to them.
Fitting the fascia on Contemporary
models.
The contemporary fascia consists of three
parts. Two sides and a top. These are held in
Figure 11.
place with six magnets. Fit the firefront
assembly before the fascia. To do this align
the four holes in the firefront assembly with those
on the heater. Secure with the four screws
supplied.
1. Lay the three fascia parts face down on a flat
surface as in figure 11. Each side trim has a small
tab at the top. Position the tab to the outside upper
edge (See figure 11).
2. Locate the tabs into the fold on the top edge of
the top trim.
3. Locate the six magnets on the side trims as in
figure 12. Note that bottom edge of the the upper
magnets are in line with the bottom of the top
Figure 12.
trim.
Page 11
Advertisement
