Baxi 940 Installer And Owner Manual page 6

Section Heading
10. BURNER & SUPPLY PIPE INSTALLATION
10.1 Burner and supply pipe installation.
10.2 Preliminary burner checks.
10.3 Inlet pressure check.
11. CERAMIC WALLS INSTALLATION
12. FITTING THE CERAMIC FUEL EFFECT
13. FITTING THE FASCIA
14. FULL OPERATING CHECKS
14.1 Check the control settings.
14.2 Check for spillage.
14.3 Flame supervision and spillage monitoring system.
15. FINAL REVIEW
16. SERVICING & PARTS REPLACEMENT
16.1 Checking the aeration setting of the burner.
16.2 To remove the ignition microswitch.
16.3 To remove the gas shut-off microswitch.
16.4 To remove the fascia.
16.5 To replace the control slide unit.
16.6 To replace the control slide button.
16.7 To remove the burner unit.
16.8 To remove the electronic ignition generator.
16.9 To remove the thermocouple interrupter block.
16.10 To remove the pilot unit.
16.11 To remove the shut-off tap.
16.12 To remove the gas flow rate controller.
16.13 To replace the burner.
16.14 To remove the main burner injector.
16.15 To remove the appliance from the fireplace.
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
CONTENTS (Continued)
Page 6
Page
25
25
25
26
26
27
28
28
28
29
29
30
31
32
32
32
33
33
33
33
34
34
35
35
36
36
37
37