To Remove The Main Burner Injector; To Remove The Appliance From The Fireplace - Baxi 940 Installer And Owner Manual

16.14 To remove the main burner injector.

(See figure 41).
1. Remove the burner - See section 16.13.
2. Remove the burner clamping screw (See figure 41).
3. Unscrew the injector from the burner.
4. Refit in the reverse order.

16.15 To remove the appliance from the fireplace.

1. Remove the burner unit - See section 16.7.
2. If the fire retention is as method 1 (See section 9.1
of installation instructions), remove the screws.
If the fire retention is as method 2 (See section 9.2 of
installation instructions), slacken the hexagonal
adjusters on the cable retainers and unscrew the
thumbscrews to release the cables.
3. Refit as described in the relevant installation sections. Make sure gas soundness,
sealing, spillage test and performance are satisfactory.
©
Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Page 37
Figure 41. Main burner
Injector removal