Final Review - Baxi 940 Installer And Owner Manual

INSTALLER GUIDE
leave for one minute.
2. Set the control to the Low burning position. Isolate the gas supply at the inlet 'T'
connector. The pilot and main burner will go out. Note the time when the pilot goes
out. Listen for a snap sound at the gas tap. Note the time when the sound is
heard. This sound is caused by an electromagnetic valve shutting off the gas supply
through the tap. The valve is located in the body of the tap. The valve should operate
within 60 seconds of the pilot going out. If the valve does not operate within this
time limit do not allow the appliance to be used until the fault has been corrected.
This monitoring system must not be adjusted, bypassed or put out of
operation.
This monitoring system, or any of its parts, must only be exchanged using
authorised parts.
3. Open the isolating valve on the inlet 'T' connector. Screw on the end cap and test
for leaks.
4. Set the slider to the "Off'" position.

15. FINAL REVIEW

1. If a gap is visible between the inner sides of the fascia and the ceramic side walls,
gently slide the walls forward.
2. Visually inspect the appliance. Clean off any marks incurred during installation.
3. Advise the customer how to operate the appliance. Point out that lighting
instruction details are on the information label attached at the bottom of the appliance.
Explain to the customer that the appliance has a flame failure & spillage monitoring
system. Point out the explanation of this system shown in the owner guide under
"Operating the fire". Advise that if the fire goes out for any reason, wait at least three
minutes before relighting. Stress that if the monitoring system repeatedly shuts off the
fire, the appliance should be switched off and a specialist should be consulted.
4. Advise the customer that they should read their owner guide before operating the
fire and always follow the advice in the section headed "Cleaning your fire".
Stress that no extra ceramic fuel effect pieces must be added over and above
those supplied with the appliance and that any replacements must only be the
authorised spares. Warn that ignoring this advice could cause incomplete
clearance of the products of combustion with consequent health hazards.
6. Advise the customer that the appliance will operate to its maximum potential if the
flue is primed during the first 20 – 30 minutes of use. To do this, simply slide the
control to its highest setting. This will also burn off any carbon deposits that may have
formed during previous use.
If using the appliance for long periods it is beneficial to change between settings. This
will also help to remove any carbon deposits that may form during use.
7. Recommend that the appliance should be serviced by a competent person at least
annually.
8. If the appliance is in premises in the United Kingdom occupied by a tenant, point
©
Baxi Heating U.K. Limited 2010.
Page 30