Tail - THUNDER TIGER 4318 Christen Eagle 3D Profile EP Instruction Manual

ASSEMBLY / TAIL
Expo 3D
G202
Christen Eagle
6. Use furnished square and make sure wing is
perpendicular to the fuselage while gluing wing
and fuselage together.
7. For Expo 3D and G202, it is necessary to cut
fuselage tail so the horizontal fin could go in.
8. Epoxy the tail in place. You may use the rest
triangle balsa wood and epoxy it at the bottom of
horizontal tail.
9. Locate the tail skid, next use hobby knife to cut a
slot at the bottom of fuselage tail. Then insert the
tail skid in place.
Expo 3D
G202
Christen Eagle
10.Glue the tail skid in place as shown. For Expo 3D,
you may need to cut one end of skid so it will not
have any influence to rudder movement.
5
CUT