Coax Splice Inner Sleeve; Coax Splice Shield Sleeve; Coax Splice With Tubing Sleeve - Bell OH-58A Technical Manual

PROCEDURAL STEPS:
1. Prepare coax cable, Figure 11-26.
Refer to Table 11-5.
2. Slide the tubing, inner sleeve, and
filler sleeve onto one of the coax
cables in the order given.
3. Splice the center conductor.
the red cavity of the crimp tool.
4. Shrink the filler sleeve over the
splice. Use reflector, temperature set
at 900°F. Keep hot air away from shield
sleeve and tubing.
5. Center and shrink the shield sleeve
over the splice area so that the solder
melts and flows, Figure 11-29.
sleeve must overlap coax braid at both
ends. Use same reflector and tem-
perature. Keep hot air away from
tubing.
6. Center and shrink the tubing over
the splice area. Use reflector with
temperature set at 900°F.
Figure 11-27.

Coax Splice Inner Sleeve

Figure 11-28.

Coax Splice Shield Sleeve

Use
Shield
ELECTRICAL AND AVIONICS SYSTEM
7. Record BDAR action taken.
mission is complete, as soon as
practical, repair the equipment/system
using standard maintenance procedures.
Figure 11-29.
Tubing Sleeve
11-18. COAX SPLICE FOR RG-58C/U,
RG-233/U, RG-59B/U, AND RG-71B/U.
GENERAL INFORMATION:
coax splices in the wiring repair kit
that may be used for the different
types and sizes of coax cable.
LIMITATIONS: This is a temporary repair.
PERSONNEL/TIME REQUIRED:
1 Soldier
15 Minutes
TM 55-1520-228-BD
When
Coax Splice with
There are various
11-31