RIDGID R4092 Operator's Manual page 35

ADJUSTMENTS
DEPTH STOP ADJUSTMENTS
See Figure 57.
The depth stop is factory set to provide maximum cutting
capacity for the wheel provided with the saw. Make
adjustments if desired.
 Unplug the saw.
 To adjust the depth, loosen the wing nut located on the
depth stop.
 Turn the depth stop knob. Set the wheel to the correct
cutting depth (wheel just below the table surface). Lower
the cutting wheel to the table to check wheel clearance.
 Readjust if necessary.
 Tighten the wing nut.
POSITIVE STOP ADJUSTMENTS
See Figure 58.
NOTE: These adjustments were made at the factory and
normally do not require readjustment.
 Unplug the saw.
If the wheel is not perfectly vertical (0°):
 Loosen the bevel lock knob.
 Raise the motor head.
 Place a combination square beside the wheel.
 Using a wrench, turn the 0° hex bolt until the wheel is
square to the table and the hex bolt is resting on the saw
housing.
 Tighten the bevel lock knob.
If the wheel is not an exact 45°:
 Set bevel to 45°.
 Place a combination square against the wheel and set
the motor head at 45°.
 Using a wrench, turn the 45° hex bolt until the hex bolt
is resting on the saw housing.
0° HEX
BOLT
35 — English
WING
NUT
45° HEX
BOLT
DEPTH
STOP
KNOB
Fig. 57
BEVEL LOCK
KNOB
Fig. 58