RIDGID R4092 Operator's Manual page 27

OPERATION
USING THE LASER GUIDE
See Figure 40.
 Using a straight edge or square, draw a mark on the tile
with a marker or grease pencil.
 Laser switch is located on the side of "D" handle. Push
laser switch "on". Laser will produce a red line across the
work surface.
NOTE: Laser may be difficult to see in bright sunlight.
 Line up laser with mark. Make cut.
 If laser does not line up accurately see Adjustments
section.
DANGER:
Laser radiation. Avoid direct eye contact with light
source.
WARNING:
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Removing or Leaving Your Mark:
Position the laser line near the left or right edge of your mark
on the work surface. Depending on which side of the work
surface you keep, you'll leave or remove the mark.
To Cut Your Mark:
Position the laser line near or over your mark on the work
surface in order to cut the mark.
After you have become familiar with using the laser guide,
you will be able to remove, cut, or leave your mark on the
work surface. Practice will teach you the correct position for
aligning the laser line with your mark.
WARNING
• To reduce the risk of • Never operate the tool
injury, the user must without the wheel guard
read and understand securely closed.
operator's manual.
• Turn off tool, wait for
• Wear eye, hearing, the wheel to stop moving,
and respiratory and disconnect the
protection when power to the tool before
operating the tool. servicing, when changing
cutting wheels, or
• Do not remove the wheel
cleaning.
guard.
• Do not stack or store
tiles on water trays.
DANGER
LASER RADIATION AVOID DIRECT EYE EXPOSURE
MAXIMUM OUTPUT: <5mW WAVELENGTH: 630-660nm CLASS IIIa LASER PRODUCT
27 — English
LASER
SWITCH
MARK
AVOID EXPOSURE: Laser radiation emitted
from this aperture.
• Never use wheels that
ÉVITER L'EXPOSITION : Radiation laser
have openings, grooves,
or teeth on this tool.
émise de cet orifice.
• Always inspect and
replace damaged
EVITE LA EXPOSICIÓN: La radiación láser se
cutting wheels before
operating the tool. emite por esta abertura.
• Do not expose to rain
or other damp
locations.
• Do not fill water bath
above maximum
water fill line.
Fig. 40