Scanning Sequence Examples; Errors While Scanning; User Preferences/Miscellaneous Option Parameter Defaults - Symbol DS3578 User Manual

5 - 2 DS3578 With FIPS Digital Scanner Product Reference Guide

Scanning Sequence Examples

In most cases scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.

Errors While Scanning

Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.

User Preferences/Miscellaneous Option Parameter Defaults

Table • lists the defaults for preferences parameters. To change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
•
Configure the digital scanner using the 123Scan
NOTE See
miscellaneous default parameters.
User Preferences Parameter Defaults
Table 5-1
User Preferences
Set Default Parameter
Parameter Bar Code Scanning
Beep After Good Decode
Suppress Power Up Beeps
Beeper Tone
Beeper Volume
Beeper Duration
Beep on Insertion
Decode Pager Motor
Decode Pager Motor Duration
Trigger Mode
Batch Mode
Time Delay to Reduced Power Mode
Appendix A, Standard Default Parameters
Parameter
Beeper Tone on page
Default Parameters on page
2
configuration program (see
for all user preferences, hosts, symbologies, and
Parameter
Number
Set Defaults
ECh Enable
38h Enable
F1h D1h Do Not Suppress
91h Medium
8Ch High
F1h 74h Medium
F0h 20h Enable
F1h 65h Enable
F1h 72h 500 msec
8Ah Level
F1h 20h Normal (Do Not Batch Data)
92h 100 msec
5-7. The digital scanner issues a
5-4.
123Scan2 on page
Page
Default
Number
5-4
5-5
5-5
5-6
5-7
5-8
5-9
5-9
5-10
5-10
5-12
5-13
5-15
11-1).