Wireless Beeper Definitions - Symbol DS3578 User Manual

Wireless Beeper Definitions

When the digital scanner scans the pairing bar code it issues various beep sequences indicating successful or
unsuccessful operations. See
Wireless Beeper Definitions
Table 4-2
Beeper Sequence
Short low-high beeps
Short high-low beeps
Long low-long high beeps
Long low-long high-long low-long high
beeps
Four long low beeps
Five high beeps
Table 4-2 for beep sequences that occur during pairing operations.
Digital scanner has paired with the cradle.
Digital scanner has unpaired with the cradle.
Note: When connected to a remote device using SPP or HID, if a
disconnect beep sequence sounds immediately after scanning a
bar code, check the host device to determine if it received the
transmitted data. The digital scanner may have transmitted the last
bar code scanned after losing the connection.
Unsuccessful pairing attempt. See
page 4-14.
Remote device rejected connection attempt, possibly due to an
attempt to pair with a cradle that is already paired with the
maximum number of digital scanners.
1. A transmission error was detected in a scanned symbol. The
data is ignored. This occurs if a unit is not properly configured.
Check option setting.
2. When communicating with a cradle, the cradle acknowledges
receipt of data. If the acknowledgment is not received, this
transmission error beep sequence sounds. Data may still have
been received by the host. Check the host system for receipt of
transmitted data. If data was not received by the host, re-scan the
bar code.
Emitted every 5 seconds while a reconnection attempt is in
progress. See
Radio Communications
Indication
Auto-reconnect Feature on
Auto-reconnect Feature on page
4 - 3
4-14.